|
Product Details:
|
| Max. Data Rate: | 10Gbps | Connector Type: | SFP+ To SFP+ |
|---|---|---|---|
| Cable Length: | Customized Length Between 0.5-10 Meters | Wire AWG: | 30AWG Or 24AWG Optional |
| Minimum Bend Radius: | 20mm | Compatible: | Cisco, HP, Alcatel Lucent, Juniper, Brocade Or Customized |
| High Light: | fiber ethernet media converter,gigabit fiber media converter |
||
10G SFP+ Passive Direct Attach Copper Twinax Cable 30AWG Or 24AWG Optional
Description
10G SFP+ Passive Direct Attach Copper Twinax Cable at 0.5 ~ 10 Meters manufactured by ANC International Co., Limited is a type of factory terminated twinax cable used to connect switches to routers or servers. These cables consist of fixed lengths of shielded copper coaxial or fiber optic cable with fixed pluggable transceivers on either end with varying gauges from 24 to 30AWG.
The SFP+ passive direct attach cable assembly’s printed circuit paddle card has been designed to not only address the stringent mechanical interface requirements but also the higher-bandwidth signal integrity requirements for 10Gb/s per channel transmission. The cable assembly also includes robust diecast covers and an EMI girdle to assure proper EMI shielding effectiveness and termination. Cable assembly removal is enabled via a user friendly pull tab.
The passive cable assembly design has no signal amplification in the cable assembly. Electronic Dispersion Compensation (EDC) is typically used on host board designs when passive SFP+ copper assemblies are utilized. EDC allows for an extended length of passive cable assemblies.
This DAC cable is highly cost-effective way to connect two SFP/SFP+ devices for very short distances, within racks and across adjacent racks. They provide a low cost, low power and low latency interconnect solution for 10-Gigabit Ethernet, Fiber Channel and other industry standards, and are direct attached compliant and fully conform to the SFP+ MSA specifications.
Features
Support for multi-gigabit data rates up to 10.5Gbps
Data rates backward compatible to 1Gbps
Support for 1x, 2x, 4x and 8x Fiber Channel data rates
Hot-pluggable SFP 20PIN footprint
I/O Connector designed for high speed differential signal applications
Improved Pluggable Form Factor(IPF) compliant for enhanced EMI/EMC performance
Low Power Consumption < 0.5W
Power Supply :+3.3V
Compatible to: SFF 8431 SFF 8472
Temperature Range: 0~ 70 °C
RoHS Compatible
Applications
High capacity I/O in Storage Area Networks, Network Attached Storage, and Storage Servers
Switched fabric I/O such as ultra high bandwidth switches and routers
Data center cabling infrastructure
High density connections between networking equipment
Systems
| Performance | 10.5 Gpbs line speed, full duplex Bit error rate: better than 10E-12 |
| Media | Hot-pluggable, industry-standard Small Form-Factor Pluggable(SFP+) copper cable, available as 1m,3m or 5m. |
| Operating parameters | Supply voltage: 3.3V Power consumption(per end): max 0.5W |
Contact Person: Ms. Cherry Liu
Tel: 86-13798591226
Fax: 86-755-29407103
